Heat Pump Hot Water Gillieston Heights

A heat pump hot water system in Gillieston Heights heats water using energy taken from the surrounding air, and suits the larger family homes here. The plumber in Gillieston Heights sizes, supplies and installs it at a price fixed before work starts. Ring (02) 4915 2998 to match a unit to your household, or book through the form below.

Repair or replace? If the question is whether to fix the old unit or replace it, the hot water systems page walks through that call, including the gas and solar options.

Call (02) 4915 2998 Request a quote

Licensed plumbers and gas fitters · NSW Lic. 359278C

Last updated September 2026

Why Move Off an Electric Storage Cylinder?

Two different technologies

A storage cylinder heats water with an element inside the tank. A heat pump uses a fan and compressor to move heat from the outside air into the water, working like a fridge in reverse.

What that means at home

The unit sits outdoors and works through the Hunter's hot, humid summers and cool winters alike. For a household drawing a lot of hot water each day, the choice of system is worth weighing properly before the old cylinder fails.

Does Your Block Suit a Heat Pump?

Placement decides a lot. The unit needs air moving around it, a level base and room to get at it for servicing.

A cramped side passage or a spot hemmed in by a garden bed will not do
Sloping lots need a level pad, since the estates here step down a ridge towards Wallis Creek
The position is agreed with you before quoting, because a new location means extra pipework

How We Handle the Install Day

01
Position check
The spot, the clearances and the pipe route are confirmed against what was quoted.
02
Old unit out
The cylinder is isolated, drained and removed, with the water and power made safe as it comes out.
03
New unit in
The heat pump is fixed to its pad, the water lines are connected, and the tank is filled and set to your household's routine.
04
Test and handover
A full heating cycle is run, every joint is checked, the area is cleaned up and the settings are explained before we leave.

What Moves the Price?

We provide up-front, honest quotes that will always match the final price, should you decide to go ahead.

The quote itself is built on:

The tank size your household needs, since five people draw far more than two
Whether the new unit can use the old cylinder's spot or needs a fresh base and pipe runs
Whether the existing electrical supply suits the new unit, which an electrician confirms where needed
Removing the old system and getting rid of it

Heat Pumps in These Estate Homes

Big homes, heavy demand

Census figures record 65.8 per cent of local dwellings with four or more bedrooms and an average household size of 2.8. The median age is 30, which points to young families, and they run the hot water hard in the morning and again at night. A heat pump chosen for that load needs a tank large enough to keep up.

A suburb of newer houses

The census count is 1,686 dwellings, built mainly in brick veneer and render from the 1980s onwards and at pace after 2005. Area-level figures show 1,454 heat pump hot water installs across the postcode, alongside 1,644 solar units.

"[The plumber] & his young helper were courteous, well mannered & competent when replacing the solar hot water station pump at my property" Jennifer

When we're not the right call

A heat pump draws its power through the home's wiring, so a fault in that circuit or the switchboard feeding it goes to a licensed electrician. And when the old cylinder has died tonight, the emergency plumber page covers getting hot water back first, with the heat pump planned afterwards.

Heat Pump Questions Before the Swap

How long does a heat pump hot water swap take in Gillieston Heights?

The old storage unit coming out and the heat pump going in are handled as one booked job. The timing depends on the site, and you are told on the quote visit how the day will run.

Can a heat pump go on a sloping block near Wallis Creek?

Yes. It needs open air around it and a flat base, so on lots that fall down the ridge the pad is set level and the unit is kept out of enclosed corners. The quote names the position before anything is mounted.

Is a heat pump noisier than the old cylinder?

A heat pump runs a fan and a compressor, so it makes some sound where a cylinder makes none. Positioning it away from bedroom windows, where the block allows, takes care of most of it.

Do you take the old hot water system away?

We do. The old cylinder is disconnected, drained and removed as part of the job, and that removal is listed on the quote you approve.

Need a plumber? Call or send the form

Call (02) 4915 2998 or send the form below. Available 24/7, you see a fixed figure ahead of any work, and every job carries our 365-day warranty on all work.

Call (02) 4915 2998

Request a callback

Leave a name and number and a plumber will ring you back.